Silent Call Communications SD4-SS Manuel d'instructions télécharger pdf (Page 19)

Programming

The smoke detector is pre-programmed at the factory.

Address Switch Settings

The Silent Call system is digitally encoded. All Silent Call receivers

and transmitters are tested and leave the factory programmed to a

factory default address. You do not need to change the address unless

someone in your area has Silent Call products and they are interfering

with your equipment.

1. Make sure that all Silent Call transmitters in the area are turned off.

2. Located on the back of the transmitter case is a removable access

panel. Remove the access panel and take out the batteries. Note

Test Switch

Green LED

Red LED

Figure 7: Silent Call Model #SD4-SS

Wireless Smoke Detector

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Pas de commentaire

Silent Call Communications SD4-SS Manuel d'instructions Page 19